I agree with peter
need to stay with 90+-2 I think it too much but it should remain
one concern . does this apply to side panel plane on inside of cockpit? or just outside surface of hull
16. Fuselage outer surface of side panel(s) parallel projected planes intersecting with deck or bottom parallel projected planes shall create a 90 +/-2 degree angle from a point 6’’ (153. mm) from the bow to a point 6’’ (153. mm) from the stern. A maximum 1/4’’ (6.3 mm) radius is allowed on the outside top corner of the fuselage where the deck and side panel intersect. Concavities in the deck are not permitted. “
does this read ok?
need to be very clear
drop the word “approximately” the angle and tolerance covers it specifically